When using the included speakers, setup explained in this section is not required. When using speakers sold separately, use speakers with impedance of 4 Ω to 16 Ω.

If any of the speakers to be connected has an impedance of 4 Ω or more and less than 6 Ω, set "Speaker Impedance" to "4 ohms" for "Speaker Setup" in the Initial

Setup section (

p85). When setting "Speaker Impedance" from the Setup menu, press

on the remote controller, and set "2. Speaker" - "Configuration" - "Speaker

Impedance" (

p73) to "4 ohms".

„ Connect the Speaker Cables

Make correct connection between the unit's jacks and speaker's jacks (+ side to + side, and - side to - side) for each channel. If the connection is wrong, a bass sound

will not be reproduced properly due to reverse phase. The wires exposed from the tip of the speaker cable do not stick out of the speaker terminal when connecting. If

the exposed wires touch the rear panel, or the + side and - side wires touch each other, a malfunction may occur.

Front Panel≫ Rear Panel≫ Remote≫

Tabla de Contenido