Operating Elements; Conformity And Approval - Monacor JTS IN-64TH/2 Manual De Instrucciones

All operating elements and connections described
can be found on the fold-out page 3.

1 Operating Elements

1 Microphone cartridge
2 LC display: will indicate the battery status, the
chan nel group ( , , or ) and the channel (1 – 16)
during operation
3 Screw cap for the battery compartment
4 Button for switching on/switching off the trans-
mitter and for activating/deactivating the muting
(muting = transmitter will transmit neither a radio
signal nor an audio signal)
Switching on
→ Press the button
The display will be illuminated in green: The illu-
mination will be extinguished after 10 seconds if
no button is pressed.
Activating/deactivating the muting
→ Press the button
After activating the muting, the display will be
illuminated in red. The illumination will start
flashing after 10 seconds.
After deactivating the muting, the illumination
will change to green. It will be extinguished after
10 seconds if no button is pressed.
Switching off
→ Keep the button pressed until
5 Compartment for two batteries of size AA
6 Button SET to call the adjusting modes (
ter 5.1) and to confirm the adjustments
Note: When the transmitter is locked, only the adjusting
mode for the lock function can be called to deactivate the
lock again ( chapter 5.1.5).
7 Button for adjustments in the various adjusting
modes ( chapter 5.1)
– for upward selection of the channel group and the
channel
– for increasing the sensitivity
– for activating the REMOSET function for the
transmitter
– for upward selection of the identification number
– for activating the lock function
8 Button for adjustments in the various adjusting
modes ( chapter 5.1)
– for downward selection of the channel group and
the channel
– for decreasing the sensitivity
– for deactivating the REMOSET function for the
transmitter
– for downward selection of the identification num-
ber
– for deactivating the lock function
8
2 Important Notes
G
The transmitter is suitable for indoor use only. Pro-
tect it against dripping water and splash water, high
air humidity and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Insert batteries of the same type only and always
replace the batteries completely.
G
Remove the batteries if the transmitter is not used
for a longer period (e. g. more than a week). Thus,
the transmitter will not be damaged in case of bat-
tery leakage.
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the transmitter and no lia-
bility for any resulting personal damage or material
damage will be accepted if the transmitter is used for
other purposes than originally intended, if it is not
correctly operated, or if it is not repaired in an expert
way.
Dead batteries or defective rechargeable batteries
do not belong in the household rubbish; always take
them to a special waste disposal (e. g. collection con-
tainer at your retailer).
is indicated
3 Applications
chap-
The hand-held transmitter IN-64TH/ 2 with dynamic
microphone cartridge is designed for operation with
the receiver IN-64R/ 2 from JTS. The transmitter and
the receiver will create a wireless audio transmission
system operating in the UHF range of 740 – 764 MHz
with 64 preset transmission channels (divided into
4 channel groups). The transmission range will de -
pend on local conditions and may reach a maximum
of 100 m.
The REMOSET function of the system will allow
automatic frequency tuning between the transmitter
and the receiver.

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare that
the unit IN-64TH/ 2 is in accordance with the basic
requirements and the other relevant regulations of the
directive 1999 / 5 / EC. The declaration of conformity
can be found in the Internet via the JTS home page
(www.jts-germany.de).
This unit may be operated in the following countries:
DE
If the transmitter is to be put out of operation
definitively, take it to a local recycling plant for
a disposal which is not harmful to the envi-
ronment.