Menu Item 7: "Motion Detect." (Motion Detection) - Monacor security TVCCD-800ECOL Manual De Instrucciones

3. "Manual " – By pressing the key "SET" (12), the submenu for
GB
the manual white balance is called. Here the red part and the
blue part of the reproduction can directly be changed. For this
purpose select the corresponding colour ("red"/"blue") with the
keys (11) and
range from -20 to +20 with the keys
Red 0
Blue 0
Press SET to Return
Press the key "SET" (12) to return to the main menu.
8.8 Menu item 7: "Motion Detect."
(Motion detection)
Via this menu item a motion detection can be activated ("ON ") or
deactivated ("OFF") for a picture area to be selected. If "Motion
Detect." ("ON ") is selected, press the key "SET" (12) to call the
following submenu for further adjustments:
Motion Detection
Top 4
Bottom 9
Left 3
Right 10
Sensitivity 8
––––I––––
Output type POSI
Press SET to Return
24
(8) and reduce or increase their part in the
(9) and
Via the values for "Top" (upper edge), "Bottom" (lower edge), "Left"
(left edge), and "Right" (right edge) a rectangular picture cutout
can be defined in the grid of 15 x 15 in which a motion is to be
detected. For a better adjustability the picture is shown in the se-
lected cutout in a more brightened-up way (only while this subme-
nu is called).
(10).
The sensitivity of this area for a detection can be adjusted via
the value "Sensitivity" between "0" (insensitive) and "15" (very sen-
sitive) with the keys
ther to the right the "I" will be placed in the bar graph below.
A detected motion is displayed by the text insertion "Motion
Detected" after exiting the adjusting menu. For an external eva-
luation of the motion (e. g. alarm signal, illumination, alarm input of
a video recorder, or similar items) a signal is in addition sent to the
output "M/D OUT" (18). The parameter "Output Type" defines the
type of this signal:
"POSI"
"NEGA"
"ALARM"
Press the key "SET" (12) to return to the main menu.
Note: With flickering illumination the reliable detection of move-
ments may be impaired.
(9) and (10). The higher the value, the fur-
With detected motion a positive pulse of +4...5 V is
sent to the output for a time of 2.5 s ±0.5 s.
If no signal is present, the output has a voltage of
+4...5 V. With detected motion a negative pulse of 0 V
is sent to the output for the time of 2.5 s ±0.5 s.
The connection serves as a switch with open collector
characteristic. With detected motion a maximum DC
current load of 16 V/100 mA is switched to ground.