How To Change The Bag; Maintenance, Cleaning And Decontamination - Nilfisk VHS110 Z22 Serie Manual De Instrucciones

VHS110 Z22

How to change the bag

■ These operations can only be carried out by
trained and qualified personnel who must wear
adequate clothing, in compliance with the laws in
force.
■ Take care not to raise dust during these
operations. Wear a P3 protective mask.
In case of dangerous and/or toxic dust, you must
■
use the supplied safety bag for these certified
vacuum cleaners.
■ The bag must only be disposed of by qualified
personnel and in compliance with the laws in
force.
Installing the wrong paper bag for the class of dust
to be vacuumed or incorrect installation, can create a
health risk for the persons exposed.
How to replace the Safe Bag
■ Remove and put the vacuum hose in a safe and dust-
free place.
■ Close the inlet by using the relevant cap (1).
■ Release the dust container.
■ Close the connection part between the two plastic inlets
with a plastic clamp (2)
■ Remove the relevant connection (3) of the bag from the
inlet.
■ Fix together the two plastic inlets (4).
■ Close the plastic bag using the relevant band (5)
■ Insert a new safe bag, making sure the bag inlet is
sealed.
■ Wrap the plastic bag around the dust container external
wall.
■ Replace the dust container in the vacuum cleaner.
GB
Only use suitable bags for the vacuum cleaner class
you are using.
C421
WARNING!
WARNING!
Figure 12
WARNING!
Maintenance, cleaning and
decontamination
Bring the vacuum cleaner out of the ATEX classified area
before then performing any maintenance operation.
This vacuum cleaner can vacuum dust hazardous for
the health. The procedures for servicing and emptying
the vacuum cleaner including removing the dust
container, must only be performed by specialised
personnel wearing protective clothing. Do not use
without the complete filter system in place.
The precautions described below must be taken
during all maintenance operations, including cleaning
and replacing the primary and HEPA filters.
The maintenance, cleaning and decontamination
operations must only be performed with the vacuum
cleaner turned off and the plug disconnected from the
power socket.
It is absolutely forbidden to perform maintenance with
the plug connected to the socket.
Danger of electric shock!
■ If the user is performing the maintenance operations, all
the suitable precautions should be taken. The suitable
precautions include decontamination, adequate filtered
ventilation of the exhaust air from the room in which
maintenance is performed, cleaning the maintenance
area and suitable personal protection.
■ All parts of the vacuum cleaner must be considered
contaminated when they are removed from the
hazardous zone and appropriate actions must be taken
to prevent the dispersion of dust.
When maintenance or repair procedures are carried out,
all the contaminated elements that cannot be properly
cleaned must be eliminated.
These elements must be disposed of in sealed bags,
conform to applicable regulations and in accordance with
the local laws governing the disposal of such material.
This procedure must also be followed when the filters are
eliminated (primary and HEPA filters).
Compartments that are not dust-tight must be opened
with suitable tools (screwdrivers, wrenches, etc.) and
thoroughly cleaned.
The procedures for servicing and emptying the
vacuum cleaner, including removing the dust
container, must only be performed by authorized
personnel wearing protective clothing.
10
WARNING!
WARNING!
WARNING!
WARNING!
11/2016