Promax TV EXPLORER HD ISDB-T/T B Manual De Instrucciones página 125

USER'S MANUAL TV EXPLORER
Decodification
De-emphasis
Subcarrier
USB INTERFACE
DVB-ASI INTERFACE
Type
Connectors
Packets
Transmission
EXTERNAL UNITS POWER
SUPPLY
Terrestrial and Satellite
22 kHz signal
Voltage
Frequency
6
Maximum power
7
DiSEqC GENERATOR
POWER SUPPLY
Internal
Batteries
Autonomy
Recharging time
External
Voltage
Consumption
Auto power off
OPERATING ENVIRONMENTAL CONDITIONS
Altitude
Temperature range
6
If you select 5V, the maximum power shall not exceed 2.25 W (450 mA).
7 TM
DiSEqC is a trademark of EUTELSAT
10/2012
HD ISDB-T/T
B
AC-3 audio decoding for ISDB-T/T
QAM-A and DVB-S/S2.
50 μs, 75 μs (NTSC).
Digital frequency synthesis according to the TV
standard.
"USB On-the-go" for datalogger and channel plans
transfer.
Mass Storage Host: The equipment can read /
-
write on Flash drives.
Serial Port Emulation.
-
- USB CDC: (Communications Device Class).
1 DVB-ASI input and 1 DVB-ASI output.
Female BNC, impedance 75 Ω.
Transport Stream of 188 or 204 bytes (automatic
detection).
Packet or burst mode.
Through the RF input connector.
External or 5/13/15/18/24 V.
Selectable in satellite band.
0.65 V ± 0.25 V.
22 kHz ± 4 kHz.
5 W.
According to DiSEqC 1.2 standard.
7.2 V 12 Ah Li-Ion battery.
> 4.5 hours in continuous mode.
3 hours up to 80% (instrument off).
12 V.
40 W.
Programmable. After the selected amount of
minutes without
Deactivable.
Up to 2000 m.
From 5 to 40 °C (Automatic disconnection by excess
, ITU-T J.83/B,
B
operating on any control.
Page 9