Satcr Function - Promax TV EXPLORER HD ISDB-T/T B Manual De Instrucciones

When selecting the COMMANDS option in the Spectrum Analyser mode
[13] in the screen will appear a dynamic execution line in order to use with the
positioner commands: DRIVE EAST / WEST. This allows to carry out a fine adjustment
in steps or in seconds to aim the antenna through the rotary selector
Press the DiSEqC key
execution mode and to locate the mark cursor on the frequency or channel.
5.26

SatCR function

By means of function SatCR it is possible to control the devices of a TV installation
satellite that are compatible with the SatCR
which allows to concentrate manifold down frequencys (slots) by an only cable. By this
way each user using a slot can tune and decode any signal present in the satellite.
In order to select the SatCR function, press the DiSEqC key
panel, and using the rotary selector
the configuration options that users can modify: slot selection, number of slots, device
address, Frequency sep, pilot signal activation, and finally the frequencies corresponding
to each slot.
9
SatCR is a trademark of STMicroelectronics.
Page 96
USER'S MANUAL TV EXPLORER
Figure 69.- DiSEqC commands: DRIVE
[21] on frontal panel in order to quit the commands
[1] activate the SatCR option. In the display are
9
technology (Satellite Channel Router),
HD ISDB-T/T
B
[1].
[21] from frontal
10/2012