Promax TV EXPLORER HD ISDB-T/T B Manual De Instrucciones página 141

USER'S MANUAL TV EXPLORER
Skin
Light Sensor
Power measure:
Ter. Identify
Analog. Identify
Min. Ter. Power
Min. Ter. Level
QAM-A Identify
Min. Sat. Power
C/N
Identify Timeout
Sat Band
10/2012
HD ISDB-T/T
B
Sets the display (skin). It is possible to add new types
through the USB port.
It activates a light sensor to automatically adjust the
display contrast and brightness. Options are: High
contrast (with high luminosity), Low contrast (with low
luminosity) and AUTO.
It allows you to select between two options to measure
power: Integrated or Extrapolated. The integrated
method performs a calculation based on the true RMS
value for any type of signal. The extrapolated method is
an approximation to a power value according to known
power values.
Selects the type of terrestrial digital signal, DVB-C or
ISDB-T/T used by AUTO-ID and EXPLORER functions.
B
It enables (ON) / disables (OFF) the detection of
analogue signals.
Sets the minimum power for a terrestrial digital signal to
be identified.
Sets the minimum level for a terrestrial analogue signal
to be identified.
It activates the identification (YES/NO) of QAM-A
modulated signals.
Sets the minimum power for a satellite digital signal to
be identified.
Defines the C/N measuring method between Auto or
Reference Noise (Manual), used to determine the
frequency where noise level will be measured in the
spectrum analyser mode.
Sets the maximum time that the equipment will carry out
the identification of a channel unknown before going to
the next one.
(Only satellite band).
Selects the C-band or Ku/Ka-band for tuning satellite
signals.
Page 25