Isdb-T/T B (Cofdm) Digital Channel Configuration - Promax TV EXPLORER HD ISDB-T/T B Manual De Instrucciones

5.13.3 ISDB-T/T
B
Press the Measurements Configuration
CONFIGURATION menu and turn the rotary selector
Select the signal ISDB-T/T
COFDM modulation are described below:
1) Guard Interval
The Guard Interval parameter corresponds to the dead time between symbols, its
purpose is to permit a correct detection in multi path situations. This parameter is
defined according to the symbol length: 1/4, 1/8, 1/16, 1/32. To modify its value, by
turning the rotary selector
then press it : a menu with the available values will appear. Turning the rotary selector
[1] select the desired value and finally press it to validate.
2) Mode
Transmission mode identification based on the separation of OFDM carrier
frequencies. In the case of Brazil, the separation of frequency must necessarily be
about 4 kHz, 2 kHz or 1 kHz, respectively for modes 1, 2 and 3. The number of
carriers varies depending on the mode, but the useful rate of each mode must
necessarily be exactly the same in all modes. To modify its value, by turning the rotary
selector [1], place the marker over the Mode field and then press it : a menu with
the available values will appear. Turning the rotary selector
value and finally press it to validate.
3) Spectral Inv.
This option enables spectral inversion to be applied to the input signal, though in the
majority of cases it should be in the OFF position (not inversion).
4) Enable ASI INTERFACE
It enables or disables the ASI interface. Refer to that section.
5) TS Layers
It indicates layers used by the demodulator to generate the TS. The default value is
"A + B + C", so the TS will be built with data from these three layers. If Partial
Reception is available, you should choose "A" if you want just a TS with partial
reception information. Keep in mind that the layers assigned to the TS will affect the
MPEG-2 / H.264 Decoder so the list of services can change depending on the
selected layers.
Page 44
(COFDM) Digital Channel Configuration
, which uses COFDM modulation. Parameters related to
B
[1], place the marker over the Guard Interval field and
USER'S MANUAL TV EXPLORER
[17] key to access to the
[1] until the SIGNAL option.
HD ISDB-T/T
B
[1] select the desired
10/2012