Promax TV EXPLORER HD ISDB-T/T B Manual De Instrucciones página 172

As well as the video carrier / noise level ratio (C/N) (41.0 dB in previous figure), the
frequency or channel (depending on the tuning mode selected) and the level of the video
carrier and video/audio ratio are also shown. When representing the spectrum by means
of pressing [13] key, the NOISE cursor is automatically positioned to a side of the
carrier tuned. That is, the cursor will indicate the point where the value of the noise is
lower, whenever the C/N (AUTO) option is selected from the PREFERENCES
menu. If the C/N (MANUAL) option has been activated the frequency where noise level
will be measured will correspond to the position of the vertical discontinuous green-
coloured cursor that appears in the spectrum graph
In order to modify this frequency, press the measurement configuration
[17] key, to accede to the CONFIGURATION menu. By turning the rotary selector
[1], locate the NOISE cursor on the position of the marker using
option (see section "5.16.1 Markers") or directly enter the value of the new
MARKER
noise frequency by means of
When measuring channels in the satellite band or digital channels, to measure the
C/N ratio correctly, the bandwidth of the channel must be defined previously, using the
Channel BW option on the Measurements Configuration menu that appears when
pressing the [17] key.
Page 56
USER'S MANUAL TV EXPLORER
option.
NOISE FREQ
Figure 29.- NOISE cursor. C/N (MANUAL).
HD
[13].
NOISE FREQ. TO
ISDB-T/T
B
[22]
10/2012