Setting The Clock; Radio Operation - Aiwa CDC-X907M YU Manual De Instrucciones

SETTING THE CLOCK

To turn the unit on
You can turn the unit on by pressing any
button on the front panel except OPEN and
the Jog Dial.
1
With the unit on, press and hold SELECT
for more than 2 seconds until the clock
indication appears.
2
Press TUNE i, then rotate the Jog Dial
to set the hour.
Press TUNE k, then rotate the Jog Dial
to set the minute.
Rotate the Jog Dial clockwise to go forward.
Rotate the Jog Dial counterclockwise to go
backward.
3
Press SELECT.
The clock starts working from 0 second.
To have the clock displayed when the unit is on
Press DISP. To return the unit to its former
display, press DISP again.
5
ENGLISH

RADIO OPERATION

1
Press FUNCTION repeatedly to select
the band from among F1 (FM1), F2
(FM2), F3 (FM3), A1 (AM1) and A2 (AM2).
The band indications appear cyclically in
order.
• F1, F2 and F3 share the same frequency
range.
• A1 and A2 share the same frequency range.
Band Frequency
indication indication
2
Press (and hold for more than 2
seconds) either TUNE i or TUNE k to
tune in the desired station.
The unit starts scanning and tunes in a station
automatically (seek tuning).
Press TUNE i to increase and TUNE k to
decrease the frequency.
Press the button again to cancel seek tuning.
Repeat the procedure until the desired station
is tuned in.
Note
If you press (for less than 0.5 second at a
time) either TUNE i or TUNE k, the frequency
increases or decreases step by step.
3
Adjust the volume with the Jog Dial.