Unox ChefTop XVC 055 Manual De Instrucciones página 8

Safety regulations
Maintenance, inspection and cleaning
We recommend the oven cavity is cleaned on a daily basis, in order to maintain acceptable hygiene standards
and to prevent the stainless steel inside the cavity from being ruined. We would therefore recommend the use
of the Rotor.KLEAN™ washing system, code XC405, which offers automatic washing of the oven cavity.
Caution!
If the appliance is not cleaned or not cleaned thoroughly enough, grease or remnants of food which have
accumulated inside the oven cavity may start to burn - fire hazard!
To prevent corrosion from occurring inside the oven cavity, the appliance should be cleaned every day, even if
it is only used for steam cooking purposes.
Do not clean the appliance with a high-pressure cleaners, jets of hot water or high-pressure steam. Only use
detergents which have been recommeded by the appliance manufacturer.
Detergents from other manufacturers may damage the appliance and therefore invalidate the guarantee. Do
not use abrasive substances or corrosive detergents.
Daily cleaning of the oven cavity seal using a non-abrasive detergent will extend the working life of the appliance.
To clean the oven cavity manually, proceed as follows:
Switch on the oven, set the temperature to 55°C and the steam level to 100%, run for 10 minutes, then leave
to cool and clean with a damp cloth.
Do not use acidic products or abrasive tools and products.
Do not use jets of water or pressurised steam to clean the outer surfaces of the oven. Clean steel areas using
a damp cloth and specially formulated products.
Do not use acidic products, or products containing ammonia.
Installation, inspection, maintenance and repair work
Danger: high voltage!
Installation, inspection, maintenance and repair work should be carried out by qualified, suitably trained
personnel. Before any work is carried out, the appliance should be disconnected from the electricity supply.
If the appliance is placed on a support structure on wheels, make sure that any movement will not damage
electrical wiring, water pipes, exhaust pipes or any other components.
Avoid placing sources of heat near the appliance.
If the appliance is on wheels, its freedom of movement must be limited so that, if shifted, it does not damage
electrical wiring or water pipes in any way.
When moving the appliance, make sure the electrical wiring, water pipes and exhaust ducts have been
disconnected properly. If the appliance is moved back into its original position, make sure that the anti-shift
safety lock is applied, and that all electrical wiring, water pipes and exhaust pipes are connected in compliance
with current standards.
To ensure the appliance remains in perfect technical condition, maintenance work should be carried out at
least once a year, by a partner organisation as recommended by the Assistance Service.
English
8