Connect The Drain Hose; Connect The Inlet Hoses To The Water Taps; Level The Washer - Maytag MAT14PD Instrucciones De Instalación

2. Attach hose to bottom inlet valve opening first.
A
B
A. Cold water inlet valve
B. Hot water inlet valve
3. Attach second hose to top inlet. Tighten couplings by hand;
then use pliers to make an additional two-thirds turn.
NOTE: Inlet valve threads are plastic. Do not strip or
cross-thread.

Connect the drain hose

NOTE: Slide washer onto cardboard or hardboard before
moving across floor.
1. Move washer close to final position.
2. Put "hook" end of drain hose into laundry tub or standpipe.
3. Estimate the length of drain hose needed when washer is in
final position. Hose must be cut exactly to length so "hook"
end is held tightly over edge of standpipe.
If drain hose is too long, cut
straight end of hose. (Do not
cut the "hook" shaped end
of the drain hose.)
NOTE: Do not force excess
length of drain hose down the
standpipe. This could cause
siphoning.
4. Place the hose clamp over the
washer drain connector. Push
the drain hose onto the washer
connector. Use pliers to open
clamp and slide clamp over
drain hose. Check for good fit.
5. Measure and mark a point approximately 406 mm (16") from
the plug end of the shipping strap. Cut shipping strap at this
point.
406 mm (16")
6. Check that hose is not twisted or kinked
and is securely in place.
Put "hook" end of drain hose into
standpipe. Tightly wrap the shipping
strap around the standpipe. Push plug
into the nearest hole in the shipping
strap.

Connect the inlet hoses to the water taps

1. Before attaching water inlet hoses to the water taps, run water
through both taps into a bucket. This will get rid of particles in
water lines that might clog hoses. Mark which is the hot water
tap.
2. Install a black plastic tap adapter on each inlet hose.
3. Attach bottom hose (inlet marked "H") to hot water taps.
Tighten coupling to taps by hand.
4. Attach top hose (inlet marked "C") to cold water taps. Tighten
coupling to taps by hand.
5. Use pliers to make an additional two-thirds turn to each
coupling.

Level the Washer

Install the front leveling feet
1. Stack two corner posts on top of each other. Tilt washer
backward and insert corner posts 76 mm (3") in from one side
of washer as shown. Repeat with other corner posts on other
side of washer.
2. Use the leveling legs and nuts from parts package. Screw nut
down to within 13 mm (1/2") from base.
B
A. 13 mm (1/2")
B. Base
C. Nut
3. Insert legs into correct holes at
each front corner of washer until
nuts touch washer. Do not tighten
nuts until the washer is leveled.
4. Tilt washer backward and
remove corner posts. Gently
lower washer to floor.
5. Move washer to its permanent
location. Remove cardboard or
hardboard from under washer.
A
C
7