Setting Into Operation - Monacor TVCCD-130A Manual De Instrucciones

4 Setting into Operation

1) Mount the camera in the desired position.
2) Connect the video output (4) via a 75 Ω coaxial
cable to the video input jack of the monitor or a cam-
era switcher resp. video splitter. Observe the correct
75 Ω termination.
3) Connect the audio output (3) via a cable with phono
connectors to the audio input of the monitor.
4) For the power supply of the camera a regulated 12 V
power supply (e. g. PS-362ST or PS-128A by
MONACOR) is necessary. The current consumption
is approx. 110 mA. For the connection to the low
voltage jack (5) a plug of 5.5/2.1 mm (outside/inside
diameter) is necessary. Connect the positive pole to
the centre pin of the plug.
5) After applying the 12 V supply voltage the camera is
ready for operation. Arrange the camera exactly for
the monitoring range, and adjust a clear picture by
turning the lens (2).
5 Specifications
Image sensor: . . . . . . . . . 8.5 mm CCD chip (
Synchronization: . . . . . . . hor. 15 625 Hz, vert. 50 Hz
Number of pixels: . . . . . . hor. 537 x vert. 597
Resolution: . . . . . . . . . . . 420 lines
Lens: . . . . . . . . . . . . . . . . 1 : 2.0/4 mm (63°)
Minimum illumination: . . . < 1 Lux
S/N ratio: . . . . . . . . . . . . > 46 dB
Video output: . . . . . . . . . 1 Vpp, 75 Ω
Audio output: . . . . . . . . . 50 mV
Admissible ambient
temperatur range: . . . . . . 0 – 40 °C
Power supply: . . . . . . . . . 12 V , 110 mA
Dimensions of
the camera: . . . . . . . . . . Ø 22 mm x 75 mm
Weight: . . . . . . . . . . . . . . 120 g
According to the manufacturer.
Subject to technical change.
GB
1
/ ")
3
7