Maintenance - baltur BTG 15P Manual De Mantenimiento, Uso E Instalación

MAINTENANCE

The burner does not require special maintenance, but it is good practice to check periodically that the gas filter is clean and that the ignition
electrode is efficient. It is also necessary to verify that the ignition electrode's spark is produced between the same electrode and the disk.
The combustion head may need cleaning. Take care during re-assembly to exactly centre the electrodes (one for switching on and one
for flame detection) to prevent these going to ground and blocking the burner. Most of the components can be inspected by removing the
housing; to inspect the head you must remove the mixing unit, proceeding as explained below.
1) Undo the lid screw "A" to gain access to the interior of the
burner.
2) After disconnecting the gas train, unscrew the 3 screws "B"
that fasten the flange of the gas outlet connector to the burner
plate.
3) Remove the mixer unit in the picture.
13 / 20
0006080895_200903
E
N
G
L
I
S
H