Maintenance - baltur RiNOx 35L Manual Del Usuario

NOZZLE
Burner model
RiNOx 35L
(w ith pre-heating)
NOTE:
The values repoted on this table are
referred at the 12% CO at the mean
2
sea level and with 0.1 mbar pressure
in the combustion chambre.

MAINTENANCE

Most components can be inspected by removing the hood. To inspect the head you must disassemble the component-carrying
plate which can be hung on hung on the burner body in two different positions to make work as practical as possible. The
motor, transformer and solenoid valve are connected via a connector while the photo-resistor is push-locked into place.
2) Undo the 4 screws of the plate, as indicated,
in order to access nozzle, electrodes and pre-
heater (if fitted).
20
Pump
Burner flow-rate
TYPE pressure
GPH bar
0,85
0,75
12
0,60
0,50
0,40
NOTE:
The values indicated in the table are purely
indicative; for best burner performance adjustment
needs to be made in accordance with the demands
of the particular boiler type.
ADJUSTMENT DATA
3
Air gate adjustment
kg/h Set-point n°
3,40 3,5
2,90 2,5
2,40 2
1,80 1,5
1,50 1
1) Undo the lid screw to gain access to the
interior of the burner.
3) The plate must be hung up as illustrated in
fig. C.
LIGHT OIL BURNER
2
Disc position
adjustment
Set-point n°
6
4,5
3
0,5
0,5
RECOMMENDED NOZZLES
STEINES type ......... S 60°
MONARCH type ..... R 60°
DANFOSS type ....... S 60°
N° 0002933250
Rev. 26/09/00