Programmed Playback (Cd/Usb/Sd) (1 - Teac CR-H260i Manual Del Usuario

Programmed Playback (CD/USB/SD) (2)
3
Press the ENTER button.
p When you press the ENTER button, the track num-
ber that is currently blinking will be added to the
program.
Example:
To select track 2:
Press "0, " "0" and "2", or press "2" and then press the
ENTER button.
To select track 12:
Press "0, " "1" and "2", or press "1" and "2" and then
press the ENTER button.
To select track 123:
Press "1, " "2" and "3", and then press the ENTER but-
ton. (3-digit numbers are only for MP3/WMA files.)
p If you enter a number that is greater than the total
number of tracks, the highest available track num-
ber will appear blinking (and can be added to the
program).
For example, if you input "999, " but the media only
contains 60 tracks, "T060, " which is the highest track
number, will appear and "060" will blink.
34
4
2
Repeat steps and
tracks/files.
p If you make a mistake, press the CLEAR button to
remove the last input track/file number.
p Up to 30 tracks/files can be programmed. If you
attempt to program more than 30 tracks/files,
"PROG FULL" will appear on the display.
5
When programming has been finished,
press the PLAY/PAUSE button (7/9).
Programmed playback will start.
p After playback of all the programmed tracks/files
has finished or you stop programmed playback,
you can restart programmed playback by pressing
the Play/Pause button (7/9).
p If the PROGRAM button is pressed when playback
is stopped, all program contents will be cleared.
3
to program more