To Sweep The Grass; To Extend The Trimmer Line; To Change The Direction Of Rotation Of The Trimmer Head; Power Boost Function - Husqvarna 220iL Manual Del Usuario

To sweep the grass

The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
3. Move the trimmer head from side to side and sweep
the grass.
WARNING: Clean the trimmer head cover
each time you assemble new trimmer line to
prevent unbalance and vibrations in the
handles. Also do a check of the other parts
of the trimmer head and clean it if
necessary.

To extend the trimmer line

• When the trimmer line becomes short during
operation, tap the trimmer head on a hard, flat
surface to extend more trimmer line out. You must
operate the product at full speed to get the best
result.

Power boost function

You can use the standard mode or the power boost
function.
• Standard mode: The product is set to standard mode
when started. Standard mode saves energy and
gives maximum operation time. Standard mode is
applicable for most tasks.
• Power boost function: The power boost function lets
the product operate at high speed. The power boost
function can for example be used in areas with
thicker grass growth than usual.
To start and stop the power boost function
You can start or stop the power boost function while the
product is in operation.
14
• Push power boost button. The power boost function
is on when the LED is on.
• Push power boost button. The power boost function
is off when the LED is off.
Note: If the power trigger is released during operation,
the product starts in the last set function. If the product
automatically stops, or if the operator pushes the power
button, the product is set to the standard function again
when started.
To change the direction of rotation of the
trimmer head
You can change the direction of rotation at full speed or
at stop position. At start, the trimmer head is set to turn
clockwise.
• Push the left button (A) to set the direction of rotation
to counterclockwise.
A
• Push the right button (B) to set the direction of
rotation to clockwise. The green LED shows the
direction of rotation that is used.
Note: It is easier to tap out the trimmer line to make it
longer when the trimmer head turns clockwise.

Automatic shutdown function

The product has an automatic shutdown function that
stops the product if the product is not used. The green
LED for start/stop indication goes off and the product
stops after 120 seconds.
B
1511 - 002 - 22.07.2020