To attach the cutting attachment guard
•
Attach the cutting attachment guard (A) to the shaft
(C) with the screws (B).
B
C
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
Before you operate the product
•
Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches.
•
Do an overhaul of the product.
•
Do the safety inspections, maintenance and
servicing that are given in this manual.
•
Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
•
Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
•
Make sure that all nuts and screws are tight.
•
Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
To connect the battery charger
1. Connect the battery charger to the voltage and
frequency that is specified on the rating plate.
2. Put the plug in a grounded socket outlet. The LED
on the battery charger flashes green one time.
Note: The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
12
A
Operation
To charge the battery
Note: Charge the battery if it is the first time that you use
it. A new battery is only 30% charged.
1. Make sure that the battery is dry.
2. Put the battery in the battery charger.
3. Make sure that the green charging light on the
4. When all LEDs on the battery come on, the battery is
5. To disconnect the battery charger from the mains
6. Remove the battery from the battery charger.
battery charger comes on. That means that the
battery is connected correctly to the battery charger.
fully charged.
socket, pull the plug. Do not pull the cable.
1511 - 002 - 22.07.2020