Operation Ta1100; Grass Trimming With A Trimmer Head; To Cut The Grass; To Trim The Grass - Husqvarna 535FBX Manual Del Usuario

5. Turn the output shaft until one of the holes in the
drive disc aligns with the related hole in the gear
housing.
WARNING: Make sure that the higher
section of the drive disc installs correctly
in the center hole of the cutting
attachment. If the cutting attachment is
installed incorrectly, it can result in
serious injury.
6. Put the locking pin (C) in the hole to lock the shaft.

Grass trimming with a trimmer head

To trim the grass

1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
4. Use 80 % throttle when you cut grass near objects.
36
7. Turn the trimmer head /plastic blades (H) in the
opposite direction from which the trimmer head/
plastic blades rotates.

Operation TA1100

To cut the grass

1. Make sure that the trimmer line is parallel to the
ground when you cut the grass.
2. Do not push the trimmer head to the ground. This
can cause damage to the product.
3. Move the product from side to side when you cut
grass. Use full speed.

To sweep the grass

The airflow from the rotating trimmer line can be used to
remove cut grass from an area.
1. Hold the trimmer head and the trimmer line parallel
to the ground and above the ground.
2. Apply full throttle.
H
H
1301 - 003 - 20.11.2019