2Installing The Software; Piezas Necesarias; 3Start Up Of The Barcoiq Server - Barco IQ PRO R210L Manual Del Usuario

Point to point configuration
A
Imagen 15-4
In case of a temporary configuration (demo purposes) one can use the point to point configuration, the con-
nection being done via RJ45 connections using a crossed UTP cable.
15.4.2 Installing the software
An Administrator password has been installed for security reasons (worm and virus protection):
Password : Barco (case sensitive !)

Piezas necesarias

• installation CD (delivered)
• PC
How to install the client software ?
1. Install the client software from the CD ( Setup file )
How to install the iQ server software ?
1. The server software is by default installed on the projector.
if necessary, reinstall it from the CD.
15.4.3 Start up of the BarcoIQ Server
Starting up
There are 2 methods to start up the BarcoIQ Server
• Manual start up (via the General menu)
• Automatic startup at projector startup: this is done by defining the state of the BarcoIQ Server during a "Projector ON state"
and a "Projector standby state" .
Manual start up: How to start up/shut down/reset the BarcoIQ Server ?
1. Press MENU to activate the Toolbar
2. Press → to select General
3. Press ↓ to Pull down the General menu
4. Use ↑ or ↓ to select iQ Pro Server
5. Press → to open the menu
6. Use ↑ or ↓ to select ON/OFF/Reset (imagen 15-5)
7. Press ENTER
R5976694S IQ PRO R210L/350/500 20122003
B
15. Red iQ
131