Connecting The Appliance; Electrical Connection - Gaggenau RW 414 Instrucciones De Uso

Ocultar thumbs Ver también para RW 414:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting the appliance

Have a technician install and connect the appliance
according to the enclosed installation instructions.
Do not remove the transportation protection devices
from the shelves and storage compartments until
the appliance has been installed.
In addition to the statutory national regulations,
observe the connection conditions of the local power
supply companies.
After installing the appliance, wait at least 1 hour until
the appliance starts up. During transportation the oil
in the compressor may have flowed into
the refrigeration system.
Before switching on the appliance for the first time,
clean the interior of the appliance (see chapter
"Cleaning the appliance").

Electrical connection

,
WARNING:
Avoid the risk of an electric shock!
,
WARNING:
Insert into a grounded 3-phase socket. Never remove
grounding phase. Do not use any adapters. Do not use
any extension cables.
,
WARNING:
Non-compliance with these instructions may result
in death, fire or an electric shock. Improper
connection of the protective conductor may result in
an electric shock. If you are in doubt whether
the appliance has been grounded properly, have
the appliance tested by a qualified electrician or
service technician.
The socket must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I.
Connect the appliance to 115 V/60 Hz alternating
current via a correctly installed socket with protective
conductor. The socket must be fused with a 10 to 16 A
fuse.
The appliance comes with a UL registered 3-wire
power cord. The appliance requires a 3-pole socket.
Please observe the following table with regard to this:
Appliance
Wine refrigerator
Check on the rating plate whether the indicated
voltage and current type correspond with the values of
your power supply. The location of the rating plate
can be found in the chapter entitled Customer
service.
,
WARNING:
Never connect the appliance to electronic energy
saver plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters
are used for photovoltaic systems which
are connected directly to the national grid. Sine-
controlled inverters must be used for isolated
applications (e.g. on ships or in mountain lodges)
which are not connected directly to the national grid.
Maximum simultaneous load
2 amps
5

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rw 464

Tabla de contenido