Prepare Measurement; Measuring Blood Pressure - Beurer medical BM 44 Instrucciones De Uso

4. Prepare measurement

Inserting battery
• Remove the battery cover
from the back of the moni­
tor.
• Insert four 1.5 V AA (alkaline
type LR 06) batteries. Make
absolutely sure that you
insert them with the correct
polarity as marked. Never
use rechargeable batteries.
• Replace the battery cover carefully.
If the battery change
urement is no longer possible and you must replace all the
batteries.
Battery disposal
• The empty, completely flat batteries must be disposed of
through specially designated collection boxes, recycling
points or electronics retailers. You are legally required to
dispose of the batteries.
• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury
is continuously illuminated, meas­
Operation with the mains part
You can also operate this device with a mains part.
When doing so, there must not be any batteries in the bat­
tery compartment. The mains part can be obtained from
specialist retailers or from the service address using order
number 071.19.
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains part
described here.
• Insert the mains part into the connection provided for this
purpose on the right­hand side of the blood pressure mo­
nitor. The mains part must only be connected to the mains
voltage that is specified on the type plate.
• Then insert the mains plug of the mains part into the
mains socket.
• After using the blood pressure monitor, unplug the mains
part from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains part, the blood pressure monitor loses the date
and time setting but the saved measurements are retained.

5. Measuring blood pressure

Please ensure the device is at room temperature before
measuring.
20