Skil 3310 Manual De Instrucciones página 49

Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two
different ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Vertical bevel angle
Floor strip/moulding
Inner corner
Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is
located
Outer corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is
located
Always make trial cuts with the mitre angle setting
first on scrap wood.
Placed
against
the fence
0°
Left side
45° left
Bottom edge on Bottom edge on
saw table
... to the left of ... to the right of
the cut
45° right
Bottom edge on Bottom edge on
saw table
... to the right of ... to the left of
the cut
49
Lying flat
on the
saw table
Right side Left side
45° right
Upper edge
saw table against the
fence
... to the left of
the cut the cut
45° left
Bottom edge
saw table against the
fence
... to the right of
the cut the cut
45°
Right side
0° 0°
Bottom edge
against the
fence
... to the left of
the cut
0° 0°
Upper edge
against the
fence
... to the left of
the cut