Skil 3310 Manual De Instrucciones página 40

Operate the power tool only when the
•
work area to the workpiece is clear of any
adjusting tools, wood chips, etc. Small pieces
of wood or other objects that come in contact
with the rotating saw blade can strike the
operator with high speed.
Always firmly clamp the piece to be worked.
•
Do not saw workpieces that are too small to
clamp. Otherwise, the clearance of your hand to
the rotating saw blade is too small.
Operate the machine only for materials
•
mentioned under "Intended Use". Otherwise,
the machine can be subject to overload.
• If the saw blade should become jammed or
when interrupting work, switch the saw off
and hold the workpiece until the saw blade
comes to a complete stop. Never attempt to
remove the workpiece as long as the saw
blade is in motion, otherwise kickback may
occur. Determine and correct the cause for the
jamming of the saw blade.
Do not use dull, cracked, bent or damaged
•
saw blades. Unsharpened or improperly
set saw blades produce narrow kerf causing
excessive friction, blade binding and kickback.
Always use saw blades with correct size
•
and shape (diamond versus round1 of
arbor holes. Saw blades that do not match
the mounting hardware of the saw will run
eccentrically, causing loss of control.
• Do not use high speed steel (HSS1 saw
blades. Such saw blades can easily break.
• Do not touch the saw blade after working
before it has cooled. The saw blade becomes
very hot while working.
Never operate the machine without the
•
insert plate. Replace a defective insert plate.
Without flawless insert plates, injuries are
possible from the saw blade.
Do not use the saw without guards in
•
position.
40