Skil 3310 Manual De Instrucciones página 50

Ceiling Strips/Mouldings (According to US Standard1
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the standard
mitre angles of 31.6° (horizontal) and 33.9° (vertical) must be set. The following table
contains instructions for sawing ceiling strips/mouldings.
Settings
Vertical bevel angle
Ceiling strip/moulding
Inner corner
Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is
located
Outer corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is
located
Placed
against
the fence
0°
Left side
45° right
Bottom edge Bottom edge
against the
fence
... to the right of ... to the left of
the cut
45° left
Bottom edge Bottom edge
against the
fence
... to the right of ... to the left of
the cut
50
Lying flat
on the
saw table
Right side Left side
45° left 31,6° right
Upper edge
against the against the
fence
... to the left of
the cut the cut
45° right 31,6° left
Bottom edge
against the against the
fence
... to the right of
the cut the cut
33,9°
Right side
31,6° left
Bottom edge
against the
fence fence
... to the left of
the cut
31,6° right
Upper edge
against the
fence fence
... to the right of
the cut