Skil 3310 Manual De Instrucciones página 39

41 Power tool use and care
aa Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it was
designed.
ba Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired.
ca Disconnect the plug from the power
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting
the power tool accidentally.
da Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
ea Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the power tools
operation. If damaged, have the power
tool repaired before use. Many accidents
are caused by poorly maintained power
tools.
fa Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
ga Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
51 Service
aa Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
ba In case of carbon brushes finish
because the use, please send the tool
to the authorized technical assistance
for substitutions. Carbon brushes out of
specification causes damages at the tool
motor.
ca If the energy cord is damaged, the
supplier must be change it by the
authorized technical assistance or
qualified personal in order to prevent risk
of electrical shock.
Safety Warnings for Chop and
Mitre Saws
• Secure the workpiece.
with clamping devices or in a vice is held more
secure than by hand.
Keep your workplace clean.
•
materials are particularly dangerous. Dust from
light alloys can burn or explode.
• Never leave the machine before it has come
to a complete stop. Cutting tools that are still
running can cause injuries.
Never use the machine with a damaged
•
cable. Do not touch the damaged cable
and pull the mains plug when the cable is
damaged while working. Damaged cables
increase the risk of an electric shock.
• Never stand on the power tool.
injuries can occur when the power tool tips over
or when inadvertently coming into contact with
the saw blade.
• Make sure that the guard operates properly
and that it can move freely. Never lock the
guard in place when opened.
Keep hands away from the cutting area while
•
the machine is running. Danger of injury when
coming in contact with the saw blade.
Never remove cutting remainders, wood
•
chips, etc. from the sawing area while the
machine is running. Always guide the tool arm
back to the neutral position first and then switch
the machine off.
Guide the saw blade against the workpiece
•
only when the machine is switched on.
Otherwise there is damage of kickback,
when the saw blade becomes wedged in the
workpiece.
39
A workpiece clamped
Blends of
Serious