Special Workpieces - Skil 3310 Manual De Instrucciones

Cutting Off
– Firmly clamp the workpiece as appropriate for
its dimensions.
– Adjust the requested horizontal and/or vertical
mitre/bevel angle.
– Switch on the machine.
– Press lever 1 towards right side and slowly
guide the tool arm downward by handle 2.
– Saw through the workpiece applying
uniform feed.
– Switch off the machine and wait until the saw
blade has come to a complete stop.
– Guide the tool arm slowly upward.

Special Workpieces

When sawing curved or round workpieces, these
must be especially secured against slipping. At the
cutting line, no gap may exist between workpiece,
fence and saw table.
Provide for special fixtures, if required.
Replacing Insert Plates
(see figure K)
The red insert plates 7 can become worn after long
use of the machine.
Replace defective insert plates.
– Bring the power tool into the working position.
– Unscrew the screws
Phillips screwdriver and remove the old
insert plates.
– Insert the new right-hand insert plate.
– Screw the insert plate as far as possible to the
right with the screws 39 so that the saw blade
does not come into contact with the insert plate
over the complete length of the possible
slide motion.
– Repeat the work steps in the same manner for
the left-hand insert plate.
39 using the provided
48