Disposal Instructions - Oase Bitron Serie Instrucciones De Uso

10. Storage/Wintering
If frost is expected then you must deinstall the device! Thoroughly clean the device
(see section 8. Cleaning). Check the Bitron for damages. Store the Bitron in a dry
and frost-free location. Children must not have access to the storage location.
11. Repair /cable replacement
In the case of repair /cable replacement, send the defective Bitron directly to the
manufacturer.

12. Disposal instructions

Dispose of your Bitron device in an environmentally responsible manner. Obtain
information concerning disposal from your local garbage disposal authority.
UVC bulbs may not be disposed of in household garbage. Remove the UVC bulb
from the device and return the UVC bulb to a collection point, so that an
environmentally responsible disposal can be carried out.
13. Measures in case of malfunction
If there is no improvement in the water quality 4 weeks after turning on the
Bitron, the take the following measures:
Malfunction Possible causes
Water is not 1. UVC bulb does not come on
clear
2. Cleaning rotor and quartz glass
tube are dirty
3. The flow rate of the pump is
suitable
4. Flow rate quantity through the
Bitron is not correct
5. The suspended material is
brown and sinks to the ground.
6. The pond is extremely dirty and
full of fish food
7. Fish and animal stock is too high
8. Light has no UVC capacity
GB Operating instructions
M e a s u r e s
1. Check connections
2. See 8. cleaning
3. See 5. Installation
4. See 5. Installation
5. Remove algae and leaves and improve
the mechanical filtering via Biotec 4.
Avoid debris deposits (for instance
falling leaves).
6. Check the water values and replace part
of the water if required. Use the Biotec 4
7. The following applies as a guide value:
max. 1 kg fish for 1 m³ pond water.
8. The bulb should be replaced after
8000-10000 operating hours.
GB
17