Storage/Winter Care; Repair; Disposal Instructions; Troubleshooting In Case Of Malfunction - Oase Bitron 18C Garantia, Instructivo De Seguridad Y De Operaciones

14
10.3 Clean inspection glass
1. Unplug the Bitron's power plug.
2. Switch off the pump and safeguard it from being turned on again
unintentionally.
3. Press the safety engaging lever, turn the Bitron device head in the direction
of the arrow until the stop, and pull it out carefully with the cleaning rotor.
4. Clean the inspection glass from inside and outside. Note: The inspection
glass cannot be removed!
5. Check the O-ring on the device head for damage and correct seat. The
O-ring must sit in front of the recess on the device head (see illustration).
6. Push the device head carefully into the housing. The cleaning rotor and
the quartz glass sleeve will be pushed into the rear receptacle inside the
housing in this process.
7. The interior marking on the device head must agree with the marking on
the housing (see fig.). Push the device head carefully into the housing
until the stop. Note: If the device head cannot be completely pushed on,
then check whether the clamp screw is screwed on until the stop.
8. Turn the device head in the opposite direction of the arrow using light
pressure until the stop (markings on the device head and housing point to
each other). The safety engaging lever must click into place.
9. First place the pump in service again, then plug the Bitron's power plug
into the power outlet (see chapter "Placing in service").

11.Storage/winter care

If frost is expected then you must deinstall the device! Thoroughly clean the
device (see section 10. Cleaning). Check the Bitron for damages. Store the Bitron
in a dry and frost-free location. Children must not have access to the storage
location.

12.Repair

Please return the Bitron to an authorized OASE dealer for repair. The power
cord of this device cannot be replaced. If the power cord is damaged, the
device must be disposed of.

13.Disposal instructions

Dispose of your Bitron device in an environmentally responsible manner.
Obtain disposal information from your local authorities.
UVC bulbs should not be disposed of in household garbage! Remove the UVC
bulb from the device and return the UVC bulb to a collection point so that it can
be picked up for environmentally responsible disposal.

14.Troubleshooting in case of malfunction

If there is no improvement in the water quality 4 weeks after turning on the
Bitron, take the following measures:
English