Charging The Battery; Connecting And Disconnecting The Contra-Angle Attachment; Inserting And Removing The File - Dentsply Maillefer X-Smart Easy Manual De Usuario

3. Charging the Battery

Put the handpiece into the charging stand, the light turns yellow indicating the unit
is charging. When the battery is fully charged, the light will turn green.
PRECAUTION
• Connect to AC 100-240V power only. Otherwise, malfunction will occur.
• The standard charging time is about 1 1/2 hours, but it varies depending on use, condition of
battery, temperature and if the battery is new or old.
• Notice: Older battery shorten both the charging and operating time.

4. Connecting and Disconnecting the Contra-Angle Attachment

• The contra-angle attachment can be connected to
the motor handpiece at 6 adjustable head positions.
Align the positioning pins of the contra-angle
attachment with the positioning slots of the motor
handpiece and insert the head until they click.
• When removing the contra-angle attachment, pull it
straight out. (Fig. 7)
PRECAUTION
• Before attaching and detaching the contra-angle attachment, turn the power off.
• Check that the contra-angle attachment is securely assembled to the motor handpiece.
• Before first use complete the calibration per Section 6.

5. Inserting and Removing the File

File Insertion
• Insert the file into the chuck until it stops.
• Lightly turn the file until it engages with the latch
mechanism.
• Push inwards to click.
File Removal
• Depress the push-button and pull out the file.
PRECAUTION
• Before attaching or detaching the file, turn the power off.
• After the file is locked in place, lightly pull out the file to make sure the file is locked.
• Always clean the shank of the file to be installed. Allowing dirt to enter the chuck could
cause deterioration of chucking force.
Fig. 7
Fig. 8
13