Changing The Battery - Dentsply Maillefer X-Smart Easy Manual De Usuario

I. CHANGING THE BATTERY
X –SMART
Easy uses a rechargeable battery. It can be recharged 300-500 full
™
cycles, depending on the conditions of the motor handpiece. If the operating time or
recharging time becomes shorter, replace the battery (refer to the "Changing
Battery"). When replacing, be sure to observe the following "PRECAUTIONS ON
CHANGING BATTERY". Note that Dentsply shall not be held liable for any
malfunction or failure resulting from the failure to follow the "PRECAUTIONS ON
CHANGING BATTERY".
PRECAUTIONS ON CHANGING BATTERY
• Do not open any part other than the battery cover.
• Be sure to purchase and use only a Dentsply replacement battery. Otherwise, battery may
cause damage or explode.
• Do not change the battery with wet hands. This may cause trouble due to short-circuiting of
batteries and moisture infiltrating this product.
Changing Battery
1. Turn off the power.
2. Unscrew the battery cover. Lift the back cover off
the back of the handpiece.
3. Remove the battery.
PRECAUTIONS
Ensure you pull out the cord by holding the connector. Failure to do so may cause a break in
the cord.
1. Insert the connector of the cord of new battery into the connector inside the
battery chamber, and place the battery into the chamber with care so as not
to catch the cord.
PRECAUTIONS
In case of difficulty inserting the connector into the motor handpiece, make sure the connector
is properly oriented. Do not insert it by force.
2. Close the battery cover and replace the screw. Ensure you charge the battery
before use.
PRECAUTIONS
The used lithium-ion battery is recyclable, but its disposal may not be permitted by law in your
location. Return them to your distributor if you are unsure of the proper disposal method.
Fig. 13
21