Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The jack POWER OUT may also be used to
provide power to other (light effect) units. How-
ever, the current load of the jacks POWER IN
and POWER OUT must not exceed 16 A. Oth-
erwise, a short circuit and fire may occur due to
overload.
3) Use the POWER switch to switch on the light
effect unit. The display will indicate the reset
and start process. Then the unit will switch on
the operating mode most recently saved; after a
short period of time, the display will extinguish.
When one of the control buttons MENU, UP,
DOWN or ENTER is pressed, the display will
light up for a short period of time again.
To switch off the unit after operation, use the
POWER switch.
WARNING To prevent damage to your eyes,
never look directly into the light
source for a longer period of time.
Please note that fast light changes
may trigger epileptic seizures with
photosensitive persons or persons
with epilepsy!
independent operation
select — activate
DMX mode
setting start
address
DOWN
MENU
ENTER
DOWN
UP
ENTER
Ž
Setting options via the menu
1
rotation direction
opposite for
2
UP
UP
ENTER
MENU
3
DOWN
DOWN
4
1 show program 1, slow
2 show program 1, fast
5
3 music-controlled program
4 show program 2
5 slave mode
4
Operation
Use the control buttons MENU, UP, DOWN and
ENTER to select the operating mode and various
functions (fig. 3). The display will indicate the mode
or the setting.
Button
Function
MENU select operating mode and settings options
UP
change setting, select function
DOWN
ENTER save setting and activate the function selected
Functions of the control buttons
The menu structure below shows all operating steps.
4.1 Independent operation
For independent operation, two light show pro-
grams and one music-controlled program are avail-
able:
/
= program 1, slow
/
= program 1, fast
/
= program 2
/
= music-controlled program
1) Press the button MENU repeatedly until one of
the programs is indicated on the display (please
refer to figure 3, dashed rectangle).
2) Use the button UP or DOWN to select the light
program desired.
3) Press the button ENTER to start the program
selected.
4) To select a different program, use the button UP
or DOWN and then press the button ENTER to
start the program selected.
5) For the music-controlled program, adjust the
volume of the music system to such a level that
the show program runs in accordance with the
music.
display
for upside-
down installation
MENU
MENU
DOWN
UP
UP
(ENTER)*
(ENTER)*
* use the button ENTER to save the setting
number of
reset
DMX channels
(restart)
MENU
DOWN
UP
(ENTER)*
(ENTER)*
or to activate the function selected
GB
call up factory
settings
MENU
(ENTER)*
MENU
11
Publicidad
Tabla de contenido
