Maintenance And Storage - Imetec ZeroCalc PRO PS2 2200 Instrucciones De Uso

It is recommended that you place a cloth between the iron and the fabric when using the iron
for the first time.
Before starting ironing, direct a jet of steam onto the cloth by lifting the iron slightly so that any
residual condensation comes out.
Fabrics with the following symbols may not be ironed:
IRONING WITH STEAM
Turn the steam adjustment knob (10) to the setting matching the one selected with the temperature
adjustment knob (13).
Press the steam request button (17) to iron with steam.
NOTE: It is only possible to use steam at higher temperatures, from the 2-dots position
onwards, as indicated on the temperature adjustment knob (13).
If the selected temperature is too low, water droplets may drip from the plate.
The ECO steam position can only be used from the 2-dots position onwards.
The soleplate temperature LED flashes intermittently while ironing, thereby indicating that the
selected temperature is maintained.
IRONING WITHOUT STEAM (DRY)
Avoid pressing the steam request button (17) to iron without steam.
STEAM SHOT
With this function, the product delivers steam continuously.
Press the steam button (17) three quick consecutive times to activate the "steam shot" function. In this
mode, the system delivers steam continuously.
Press the steam button again (17) to deactivate the "steam shot" function.
Position the ON/OFF switch (5) to turn the product OFF.
Unplug the power supply cable with plug (7) from the socket.
Wait for the product to cool completely before putting it away.
NOTE: If the appliance is not to be used for several weeks, wait for the appliance to
cool down completely before emptying the water reservoir completely according to the
instructions in the relevant chapter.
When the appliance is switched on again, refill the reservoir as indicated in the relevant chapter.
EMPTYING THE TANK
Position the ON/OFF switch (5) to turn the product OFF.
Unplug the power supply cable with plug (7) from the socket.
Wait for the product to cool down completely.
Open the water fill cover (1).
Turn the base of the appliance upside down so that all the water in the tank (3) flows out.
Close the water fill cover (1).
Put the appliance away.
ZEROCALC ANTI-CALC SYSTEM
Replace the anti-scale filter (18) when the filter change indicator light (8) comes on and the iron emits
a warning buzz.
Follow the instructions in the specific section INSERTING THE ANTI-SCALE FILTER.
END OF USE

MAINTENANCE AND STORAGE

EN
16