Imetec ZeroCalc PRO PS2 2200 Instrucciones De Uso página 20

NOTE: the electronic system modifies steam emission to safeguard the lifespan of the
product. The anti-scale filter (18) must be replaced as soon as possible.
Failure to replace the anti-scale filter (18) will invalidate the warranty.
EN
Press and hold the filter change reset button (9) for at least 3 seconds to confirm replacement until
the filter change indicator (8) and the steam ready indicator light (11) emit a light signal and an audible
signal.
Continue to use the iron.
CLEANING
WARNING! Make sure the plug of the appliance is
disconnected from the socket and the soleplate has cooled
down completely before cleaning the iron.
Position the ON/OFF switch (5) to turn the product OFF.
Unplug the power supply cable with plug (7) from the socket.
Wait until the iron cools down completely.
Remove any starch deposits or residue on the surface of the base of the iron (16) with a damp cloth
and non-abrasive liquid detergent.
Avoid scratching the base of the iron (16) with steel wool or metal objects.
Clean plastic parts with a damp cloth.
Then wipe with a dry cloth.
STORAGE
Fold the mono-tube in half (14) with the iron resting on its stand (12) [Fig. C].
Insert the folded mono-tube into the recess (4) sliding it inside the special clamp.
Slide the mono-tube (14) along the entire cable recess (4).
Insert the mono-tube (14) behind the second clamp [Fig. D].
WARNING! Risk of fire. Wait for the appliance to cool
completely before storing it.
This chapter describes the most common problems that can arise using the appliance. If the problems
cannot be solved with the information below, please contact the Authorised Assistance Centre.
Problem
The plate (16) remains
cold or does not heat
up.
The plate temperature
LED (14) goes on and
off.
17
TROUBLESHOOTING
Possible cause
There is no power
supply.
Normal procedure.
Solution
Check if the power supply cable plug (7)
is inserted correctly or try inserting it in
another socket.
Check whether the temperature
adjustment knob (13) is set to the
minimum temperature.
The plate temperature control LED (14)
switching ON and OFF indicates the
heating phase of the iron. The LED goes
off once the set temperature is reached.