Preparing To Install; Belt Installation - BESAFE STOKKE IZI GO MODULAR X1 Instrucciones De Uso

Preparing to install

• Carrying handle (1a)
• Head cushion (1b)
• Head space reducer (1c)
• Handle release buttons, 2x (1d)
• Shoulder straps, 2x (1e)
• Hip belt hook, 2x (1f)
• Baby cushion (1g)
• Harness buckle (1h)
• Sun canopy (1i)
• Stroller release handles, 2x (1j)
• Shoulder belt hook (1k)
• Harness height adjuster (1l)
• Stroller adapter house (1m)
Installation of the seat on the i-Size base
• Check if the ISOfix and floor support indicators on the base are green (2).
• Position the seat in the correct position on the base untill it clicks with the base and the
indicator at the front shows green (3).
• Leave the carrying handle up in the carrying position.
• When the seat is positioned rearfacing on the back seat of the vehicle, you should, if
possible, push the front seat of the vehicle backwards, so that it is in contact with the child
seat. If it is not possible to obtain contact with the child seat, push the back rest of the
front seat of the vehicle forward as far as possible (4).
• The seat is delivered with removable SIP+ (side impact protection +). This extra side
impact protection should be used on the doorside of the vehicle. It can be connected by
slotting between the seatshell and the fabric. The seat already offers high level integrated
side impact protection. This extra side impact protection improves the protection in the
side impact still further. Do not use the SIP+ on the seat when the space between seat
and door of the vehicle is too small, which might lead to a situation where the seat is not
positioned correctly on the vehicle seat.
Removal of the seat of the i-Size base
• The seat can be taken off by pulling the seat release handle at the front of the base.
EN
12
Stokke® iZi Go Modular™ X1 user guide

Belt installation

• Position the seat on the vehicle seat. Make sure the carrying handle is up in the carrying
position (5).
• Guide the hip belt of the 3-point-belt over the blue sections under the hip belt hooks and
fasten the seat belt with a ' c lick' (6).
• Guide the shoulder belt over the blue section through the shoulder belt hook at the rear
side of the seat shell (7).
• Tighten the 3-point belt by pulling the belt through the hip belt hooks and through the
shoulder belt hook until it is as tight as possible (8).
• Leave the carrying handle up in carrying position.
Positioning of the child
• Check that the shoulder strap slots are level with your child's shoulders (9).
• Pull the shoulder straps up while pressing the button of the central adjuster (10).
• Open the harness buckle (11).
• The height of the shoulder straps and the head cushion can be adjusted by pulling the
release handle upwards at the back of the seat and pulling the handle up or down (12).
• Position the shoulder straps over the marking at the sides of the seat to use the magnets
to keep the harness open while you position the child (13).
• When the child is positioned, place the shoulder straps over the child's shoulders and
close the buckle: CLICK! (14).
• Pull the harness strap through the central adjuster in the direction of the arrow straight
up/forwards. Continue pulling until the harness is a comfortable but a firm fit (15).
• You can protect your child against the sun by raising the sun canopy.
Baby cushion
The baby cushion offers extra comfort for young babies. As baby grows the thickness of the
baby cushions can be adjusted.
• 0-4 m (16).
• 4 m + (17).
Stokke® iZi Go Modular™ X1 user guide
EN
13