Installing The Microphone Unit; Installing The Digital Radio Antenna - Kenwood KDC-BT73DAB Guia De Inicio Rapido

KDC-BT73DAB, KDC-BT53U only
Installing the
Microphone unit
1
Check the installation position of the
microphone (Accessory 3).
2
Clean the installation surface.
3
Install the microphone.
4
Lay the cable up to the unit with it
secured at several positions using tape
or the like.
<
• Install the microphone as far as possible
from the cell phone.
Accessory
Fix the cable with a commercial item of tape.
3
Remove the separator of
the microphone, and stick
the microphone to the
place shown above.
Adjust the direction of the
microphone to the driver.
KDC-BT73DAB only
Installing the Digital
radio antenna
!
CAUTION
• This film antenna is exclusively for use
inside the vehicle.
• Do not install at the following locations:
- Where it may block driver's view
- Where it may obstruct operation of
safety devices such as air bags
- On movable glass surface such as rear
hatch
• Signal strength will decrease at the
following locations:
- On IR reflecting glass or where covered
with mirror type glass film
- Where it overlaps with genuine radio
antenna (pattern)
- Where it overlaps with window heating
wires
- At side of vehicle (e.g. door, front
quarter window)
- On rear window
- When glass that blocks radio signals
(e.g. IR reflecting glass, thermal
insulation glass) is used
- Reception may decrease due to noise
when windshield wiper, air conditioner,
or motor is turned on.
- Reception may decrease depending on
the direction of the broadcast station
with respect to the vehicle (antenna).
• Be sure to check the installation location
of film antenna (Accessory 4) before
installing. Film antenna cannot be
re-pasted.
• Thoroughly wipe oil and dirt from the
pasting surface with the included cleaner
(Accessory 7).
• Do not bend or damage the film antenna
(Accessory 4).
• Warm the pasting surface by turning on
the heater for example, before applying.
• It may not be possible to install on some
type of vehicle.
• Check the cable routing of the film
antenna (Accessory 4) and amplifier
(Accessory 5) before pasting.
English | 15