Using The Equipment; Ordering Replacement Parts; Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL EH 2000 Manual De Instrucciones Original

Anleitung_EH_2000_SPK7__ 18.03.15 12:28 Seite 8
GB
cooler than that from a conventional fan heater.
This is not an equipment defect.

7. Using the equipment

When the equipment is used for the first time or after
a long period of rest, it may emit an odor for a short
time. This is not a fault.
7.1 Heat output switches (Fig. 1):
Off (0)
n
Low heat output
n
Medium heat output
n
Maximum heat output
n
7.2 Thermostat control (Fig. 1 / Item 2):
Note:
The fan will start as soon as the equipment is
switched on.
The equipment will only heat up when the room
temperature falls below the temperature set on the
thermostat and the heat output switch is on.
Switch on the required heating output. Turn the
control to "max" until the required room temperature
has been reached. Then turn down the control until
you hear a clear click. The thermostat will switch the
heating element on and off automatically.
7.3 Overheating guard
In case of excessive heating, the heating function
shuts down automatically. The fan will restart.
If this occurs, turn off the equipment, disconnect the
mains plug and wait a few minutes for the equipment
to cool. After eliminating the cause (e.g. a covered
air grille), the equipment can be switched on again.
If the overheating guard triggers repeatedly, please
contact your customer service center (in Germany
ISC GmbH).
8. Cleaning, maintenance and ordering
of spare parts
Danger!
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Before carrying out any cleaning and
n
maintenance work the appliance must be turned
off, disconnected from the power supply and
cooled down.
8
Use a damp cloth to clean the casing.
n
Remove dust pollution with a vacuum cleaner.
n
8.2 Maintenance
Maintenance and repair work may only be
n
carried out by an electrical servicing contractor or
your customer service center.
Check the mains lead at regular intervals for
n
signs of defects or damage. A damaged mains
lead may only be replaced by an electrician or
the customer service responsible for your
country in compliance the relevant regulations.
There are no parts inside the equipment which
n
require additional maintenance.

8.3 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
9. Storage
Store the equipment and accessories out of
childrenʼs reach in a dark and dry place at above
freezing temperature. The ideal storage temperature
is between 5 and 30 °C. Store the equipment in its
original packaging.

10. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.