Items Supplied; Technical Data; Reciprocating Saw - Hilti WSR 22-A Manual De Instrucciones De Funcionamiento

Status
3 LEDs light up.
2 LEDs light up.
1 LED lights.
1 LED blinks.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Note
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.

3.5 Items supplied

Reciprocating saw, operating instructions.
Note
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with the product can be found at your
local Hilti Center or online at: www.hilti.com

4 Technical data

4.1 Reciprocating saw

Rated voltage
Weight
Stroke rate
Stroke
Keyless chuck for standard accessory tools
5 Operation
5.1 Safe operation 2
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Remove the battery before making any adjustments to the power tool or before changing
accessories.
WARNING
Risk of injury! Risk of kickback.
▶ Always use saw blades of adequate length. The end of the saw blade must always project beyond
the workpiece over the entire blade stroke.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293021 / 000 / 00
Meaning
• Charge status: 50 % to 75 %
• Charge status: 25 % to 50 %
• Charge status: 10 % to 25 %
• Charge status: < 10 %
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
WSR 22­A
21.6 V
8.4 lb
(3.8 kg)
0 /min ... 3,000 /min
1.1 in
(28 mm)
1/2 in
5