Manufacturer's Warranty - Hilti WSR 22-A Manual De Instrucciones De Funcionamiento

7 Troubleshooting
▶ If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
7.1 The reciprocating saw is not operational.
Malfunction
The LEDs indicate nothing.
1 LED blinks.
7.2 The reciprocating saw is operational.
Trouble or fault
The tool does not achieve full
power.
The saw blade can't be re-
moved from the chuck.
8 Disposal
WARNING
Risk of injury. Hazards presented by improper disposal.
▶ Improper disposal of the equipment may have the following consequences: The burning of plastic
components generates toxic fumes which may present a health hazard. Batteries may explode
if damaged or exposed to very high temperatures, causing poisoning, burns, acid burns or
environmental pollution. Careless disposal may permit unauthorized and improper use of the
equipment. This may result in serious personal injury, injury to third parties and pollution of the
environment.
▶ Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble
or incinerate the batteries.
▶ Batteries that have reached the end of their life must be disposed of in accordance with national
regulations or returned to Hilti.
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.

9 Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293021 / 000 / 00
Possible cause
The battery is not fully inserted.
The battery is empty.
The transport lock is engaged.
The battery is discharged.
The battery is too hot or too cold.
Possible cause
The control switch is not fully
pressed.
The battery is discharged.
The locking sleeve is not turned as
far as it will go.
Action to be taken
▶ Push the battery in until it
engages with a double click.
▶ Charge the battery.
▶ Disengage the transport lock.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.
9