Emission Levels; Tool Holder, Attachments - Festool DR 20 E Manual De Instrucciones

lease current of 30mA. Always use a cable ap-
proved for outdoor use.
– Wear suitable protection: such as ear protection,
safety goggles, a dust mask for work which gener-
ates dust, and protective gloves when working with
raw materials and when changing tools.
– Check the plug and the cable regularly and
should either become damaged, in order to avoid
a hazard, have them replaced by an authorised
after-sales service workshop.
– Always guide the cable backwards away from the
machine.
– Take care when drilling into walls as there is a dan-
ger of rupturing concealed gas/water pipes or cut-
ting through power cables.
– Only for AS/NZS: The tool shall always be supplied
via residual current device with a rated residual
current of 30 mA or less.
CAUTION! Power tool can block and cause
sudden kickback! Switch off immediately!
5.3

Emission levels

Levels determined in accordance with EN 60745 are
typically:
Sound pressure level
Noise level
Measuring uncertainty allow-
ance
CAUTION
Operating noise
Damage to hearing
Use ear protection!
Vibration emission value a
directions) and uncertainty K measured in accor-
dance with EN 60745:
Drilling in metall
Fastening
The specified emission values (vibration, noise)
L = 88 dB(A)
PA
L = 99 dB(A)
WA
K = 3 dB
(vector sum for three
h
a = 2,6 m/s
h
K = 1,5 m/s
a = 2,6 m/s
h
K = 1,5 m/s
– are used to compare machines.
– They are also used for making preliminary esti-
mates regarding vibration and noise loads during
operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with other
insertion tools or if not maintained adequately. Take
note of idling and downtimes of machine!
6 Operation
Unauthorised voltage or frequency!
Risk of accidents
Observe the specifications on the machine's
name plate.
Observe country-specific regulations.
On/off switch [1-4]
Press = ON, release = OFF
The speed of the machine depends on how far the
on/off switch is pressed in.
7 Settings
7.1 Changing the rotational direction[1-3]
• Switch to the left = clockwise
• Switch to the right = anticlockwise
8

Tool holder, attachments

Risk of injury, electric shock
Always pull the mains plug out of the socket be-
fore performing any type of work on the ma-
chine!
8.1 Tool holder in the drill spindle [2]
Bits can be inserted directly into the hexagon socket
holder of the drill spindle.
2
8.2 Chuck [1-1]
2
The chuck [1-1] is used for clamping drill bits [5] and
screwdriver bits.
2
2
Risk of injury
Clamp the tool centrally in the chuck!
DR 20 E
WARNING
WARNING
CAUTION
GB
13