Fox Live Valve Guia Del Propietario página 12

4. Install a zip tie around the center of the sensor clip.
5. Install a cable clip near the head tube on the front
sensor cable and another cable.
Do not install any zip ties anywhere between this cable clip
and the sensor clip. The front sensor cable is equipped with a
quick release to prevent cable damage in the event of a crash.
This quick release will not function if the sensor cable is zip
tied anywhere between this cable clip and the sensor clip.
6. Remove the fork air cap. Use a hex wrench to release
all of the air from the air valve. Compress the fork to
bottom out and make sure the strain relief loop in the
cable allows the cable to move freely as the fork goes
through its travel.
NOTICE
12