Danby DBC120BLS Manual Del Propietário página 10

Operating Instructions
CAN STOCKING INSTRUCTIONS
This beverage centre has a maximum capacity of 113, 355 mL cans.
1. The fi rst shelf holds eight 355mL cans, when laid horizontally two
across and two deep on either side of the gap in middle of shelf.
2. The next three shelves hold 25 cans each, when arranged vertically,
fi ve cans across, fi ve cans deep.
3. The bottom section of your beverage centre holds 30 cans, when laid
horizontally, fi ve cans across, two cans deep and three cans high.
Note: The beverage centre can accommodate up to 120, 355 mL cans by
removing the bottom two shelves and stacking cans on top of one another.
DOOR REVERSAL INSTRUCTIONS
• Remove the screws from the lower hinge assembly and door support bracket.
• Pull the door downward to remove it from the cabinet.
• Remove the screw from the upper hinge cap and then remove the two screws from the upper
hinge assembly.
• Remove the two plastic caps from the cabinet and the door plug from the top of the door.
• Install the upper hinge assembly and hinge cap on the opposite side of the unit.
• Place the door against the unit and push up until the pin in the upper hinge assembly slots into the
hole where the door plug was removed.
• Install the lower hinge assembly and door bracket support on the opposite side of the unit.
• It is recommended at this juncture to stand the unit upright and check that the door is level and
that the gasket is making a good seal with the cabinet all the way around. If the door is not level or
if the gasket is not touching the cabinet at any point, double check that all hinge screws are tight.
• Install the two plastic caps in the holes in the cabinet where the upper hinge assembly was
removed.
• Install the door plug in the top of the door where the upper hinge pin used to be.
Note: Unplug the unit
from the electrical outlet
before completing the door
reversal.
Note: If the unit is placed on its back
or side for any length of time, allow it
to remain upright and undisturbed for a
minimum of 4 hours before plugging in
to allow the coolant to settle.
7