Troubleshooting - Danby DBC120BLS Manual Del Propietário

Ocultar thumbs Ver también para DBC120BLS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Problem
No power
Cabinet temperature
is too high.
Condensation on
the cabinet, doors or
fl oor.
Beverage centre runs
continuously.
Danby Consumer Care: 1-800-263-2629
Possible Cause
A fuse in your home may be
blown or the circuit breaker
tripped.
Power surge.
Plug not fully inserted into
the wall outlet.
Temperature setting.
Door not shut properly or
opened excessively.
Recently added a large
quantity of warm bottles to
the cabinet.
High humidity conditions in
the home.
Door not shut properly or
opened excessively.
Temperature set too cold.
Door is not closed.
Door opened too long or too
often.
Close proximity to heat
source or direct sunlight.
What to do
Replace fuse or reset circuit breaker.
Unplug the appliance, wait a few
seconds and then plug it back in
Make sure the 3-prong plug is fully
inserted into the outlet.
Verify the temperature control setting.
Adjust if neccessary.
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinets. Open the door only as
needed and for short periods of time.
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible.
The condensation will subside once
humidity conditions return to normal.
Ensure that the door is fully closed
and that the gasket is sealing. against
the cabinets. Open the door only as
needed and for short periods of time
Adjust temperature to warmer setting.
Close door securely.
Minimize door opening duration and
frequency.
Do not place unit close to heat
sources or direct sunlight.
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Dbc120cblsDbc120bls-3

Tabla de contenido