Setting The Temperature; Interior Light; Shelf Instructions - Danby DBC120BLS Manual Del Propietário

Operating Instructions

SETTING THE TEMPERATURE

The temperature of the beverage centre is controlled by adjusting the thermostat control knob on the
back of the unit. To achieve maximum cooling temperature quickly:
• Turn the temperature control knob clockwise to the widest, darkest part of the graduated blue
control dial.
• Allow the unit to run at this setting for 3 - 4 hours.
• When maximum cooling is achieved, turn the temperature control knob to the middle position on
the graduated blue control dial, as per Fig. A.
• To turn the beverage centre off, turn the control knob to the "0" position, as per Fig. B. If the
beverage centre will not be used for an extended period of time, it is recommended to unplug the
unit and leave the door partially open to avoid possible formation of odors inside the unit.
Note: Wait 3 - 5 minutes before restarting the unit if operation has been interrupted.
Note: On the graduated blue dial, the thicker, darker blue indicates colder temperatures and the
thinner, lighter blue indicates warmer temperatures. The beverage centre temperature will vary
depending on the quantity of bottles stored in the unit and the frequency that the door is opened.

INTERIOR LIGHT

To manually operate the blue interior light, press the light switch situated on the left side of the interior
light housing on the ceiling of the unit. This will allow the light to remain on while the door is closed.
Note: The light will default to off. It can be turned on to run continually. Due to energy effi ciency
requirements for a beverage centre in this size, there is no option to have the light turn on when the
door opens.
DEFROST
This appliance is equipped with an automatic defrost function and does not require manual defrosting.
Defrost water from the unit is channeled into a drip tray located above the compressor. Heat transfer
from the compressor causes the defrost water to evaporate.

SHELF INSTRUCTIONS

To remove a shelf from its locked position, lift the rear of the shelf
upward and then slide the shelf out of the unit.
To replace the shelf, ensure it is resting securely on the support
brackets and then push inward until the shelf locks into place.
6