WAGNER MICRO HEAT TOOL Manual Del Propietário página 8

STARTUP
Smoke may appear during the initial start up due to the burning of manufacturing
oils. The smoke should disappear in less than a minute.
Heat tool use is safe if all safety guidelines are used, but always keep either a
container of water or an ABC fire extinguisher (suitable against Class A, B and C type
fires) within reach.
1. Plug the unit into a standard (polarized) wall outlet.
2. Turn on the unit by moving the switch to the desired setting. The motor driven fan noise will
indicate that the unit is running.
3. To use in hands-free position, refer to Hands Free Usage instructions, below.
4. When done using the tool, or in between projects, turn the heat tool OFF (0) and follow the
Cool Down procedure, page 9).
IMPORTANT:
If the blower motor in the heat gun does not turn on when the switch is set to
either LOW or HIGH, turn the switch OFF immediately. The heating element
will burn out if it is not cooled by the blower.
IMPORTANT:
Always protect glass when working near windows.
HANDS FREE USAGE
The Heat Tool has a built in wire stand for hands-free use and bench top applications as well as
cool down.
Move wire from storage position to hands
free position:
1. Turn the heat tool OFF (0)
2. Gently pinch the prongs (A) of the stand
slightly inward and pull back to remove
from storage pockets (B).
3. Release the prongs and guide the metal
stand into the notches on the side of the
heat tool (C).
4. A slight "click" sound can be heard when the stand is secured.
5. Place the heat tool on your work area as shown.
Move wire from hands free postion to storage position:
1. Turn the heat tool OFF (0) and ensure that it has cooled down
(Cool Down procedure, page 9)
2. Using both thumbs gently dislodge the wire from the notches and
push it back toward the storage pockets (D).
3. Pinch the prongs of the metal stand slightly inward and secure
into the storage pockets.
8
EN
A
B
C
D