Correct Handling Of Machine; Points In Operation And How To Stop - Dolmar PE-254.4 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 97

CORRECT HANDLING OF MACHINE

Before edging, water the area to soften the ground and make edging easier.
Before edging, check the area and remove all obstacles and objects that
could be thrown.
Plan to edge regularly to make it easier to keep a neat edge and to avoid
having to make more than one pass.
Note:
Blade depth may have to be adjusted due to differences in height between the
hard surface and the top of the grass.
Adjust the blades' depth of cut to produce a fine cut between sidewalk and
grass using a minimum blade depth, usually with about 13 mm (1/2") of the
blade into the ground.
Adjusting the blade depth
Loosen the nut on the wheel.
Move the wheel and adjust the height according to the operation, then tighten
the nut.

POINTS IN OPERATION AND HOW TO STOP

CAUTION:
Observe the applicable accident prevention regulations!
STARTING
Move at least 3 m away from the place of refuelling. Place the petrol edger on a clean piece of ground taking care that the cutting tool does not
come into contact with the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to OPERATION.
3) Primer pump
Continue to push the primer pump (2) until fuel enters into the primer pump.
(In general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
OPERATION
(2)
12
STOP
(1)

Publicidad

Tabla de contenido
loading

Tabla de contenido