Leckey Mygo Instrucciones De Usuario página 20

7.14 Attaching the
grab rail
To attach the grab rail, insert the receiving
brackets (A) in the tray slot and secure with
the plastic knob (B). Repeat on the other side
and then slide the tubes into the receiving
brackets (A) and tighten the plastic knob (C).
B
A
A
C
7.15 Attaching the Hip
Laterals
Hip laterals are used with the Pelvic Cradle.
First remove the Pelvic Harness brackets if
required by removing the screw and flange
nut (A). Lift the piece of polypropylene on
the front of the sacral support. Place the hip
lateral brackets into the slots and attach using
the flange nuts (B) and screws (C) provided.
The flange nuts should go on the front side
of the sacral support.
A