Chain Saw Safety Warnings - Dolmar AS-1812 Manual De Instrucciones

ENGLISH
1 Red part
2 Button
3 Battery cartridge
4 Lock-off button
5 Switch trigger
6 Sprocket cover
7 Knob
8 Cutter
9 Guide bar
10 Arrow
SPECIFICATIONS
Chain speed per minute (min
Length of guide bar
Saw chain
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for cutting lumbers and logs.
Safety hints
For your own safety, please refer to the enclosed safety
instructions.

Chain saw safety warnings:

DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to chain saw safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious per-
sonal injury.
1. Keep all parts of the body away from the saw
chain when the chain saw is operating. Before
you start the chain saw, make sure the saw chain
is not contacting anything. A moment of inatten-
tion while operating chain saws may cause entan-
glement of your clothing or body with the saw chain.
2. Always hold the chain saw with your right hand
on the rear handle and your left hand on the
front handle. Holding the chain saw with a reversed
hand configuration increases the risk of personal
injury and should never be done.
3. Wear safety glasses and hearing protection. Fur-
ther protective equipment for head, hands, legs
and feet is recommended. Adequate protective
clothing will reduce personal injury by flying debris
or accidental contact with the saw chain.
Explanation of general view
11 Spring
12 Sprocket
13 Boss
14 Hook
15 Hole
16 Oil tank cap
17 Oil inspection window
18 Oil tank opening
19 Tip guard
20 Lower guide
Model
–1
)
Type
Pitch
No. of drive links
4. Do not operate a chain saw in a tree. Operation of
a chain saw while up in a tree may result in personal
injury.
5. Always keep proper footing and operate the
chain saw only when standing on fixed, secure
and level surface. Slippery or unstable surfaces
such as ladders may cause a loss of balance or con-
trol of the chain saw.
6. When cutting a limb that is under tension be
alert for spring back. When the tension in the wood
GEB037-1
fibres is released the spring loaded limb may strike
the operator and/or throw the chain saw out of con-
trol.
7. Use extreme caution when cutting brush and
saplings. The slender material may catch the saw
chain and be whipped toward you or pull you off bal-
ance.
8. Carry the chain saw by the front handle with the
chain saw switched off and away from your body.
When transporting or storing the chain saw
always fit the guide bar cover. Proper handling of
the chain saw will reduce the likelihood of accidental
contact with the moving saw chain.
9. Follow instructions for lubricating, chain ten-
sioning and changing accessories. Improperly
tensioned or lubricated chain may either break or
increase the chance for kickback.
10. Keep handles dry, clean, and free from oil and
grease. Greasy, oily handles are slippery causing
loss of control.
21 Scabbard (chain cover)
22 Push nut
23 Slotted bit screwdriver
24 Filter
25 Locking ring
26 Washer
27 Limit mark
28 Brush holder cap
29 Screwdriver
AS-1812
5.0 m/s (300 m/min)
115 mm
25 AP
1/4"
42
422 mm
2.5 kg
D.C. 18 V
13