Replacing Spool With Nylon Line - Stihl FSE 52 Manual De Instrucciones

English
1
2
Push home the button (1) on the
N
spool as far as stop.
Pull the ends of the nylon line (2) out
N
of the spool.
If the spool is empty, see "Replacing
Spool with Nylon Line".
32
Replacing Spool with Nylon
Line
STIHL AutoCut 2-2
2
Always check the mowing head for signs
of wear before replacing the spool with
nylon line.
WARNING
If there are signs of serious wear,
replace the complete mowing head.
Contact your servicing dealer.
Preparations
Switch off the machine.
N
Disconnect the plug from the wall
N
outlet.
Turn the trimmer on its back.
N
Removing remaining nylon line
In normal operation, the supply of nylon
line in the head is used up completely.
Removing the spool
2
1
Hold the housing (1) steady.
N
Press in the tabs (2) and remove the
N
cover (3).
Pull the spool (4) out of the housing.
N
Install a new prewound spool.
N
N
N
N
4
3
2
5
3
2
4
5
1
Use 1.6-mm diameter nylon line.
Thread the ends of the lines through
the openings (5) in the housing (1).
Place the spool (4) in the housing.
Press home the cover (3) until both
tabs (2) engage with an audible
click
5
FSE 52