Storing The Machine; Replacing The Nylon Line - Stihl FS 45 Manual De Instrucciones

English / USA

Storing the Machine

For periods of about 3 months or longer
: Drain and clean the fuel tank in a
well ventilated area.
: Dispose fuel properly in accordance
with local environmental
requirements.
: Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
: Remove, clean and inspect the
cutting tool.
: Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
30

Replacing the Nylon Line

STIHL AutoCut C 5-2
Always inspect the mowing head for
signs of wear before replacing the nylon
line.
A mowing head with signs of severe
wear must be replaced as a
complete unit.
Preparartions
: Shut off the engine.
: Lay your trimmer on its back with
the mowing head facing up.
1
2
3
Removing Remaining Nylon Line
In normal operation the line supply
in the mowing head is used up
completely.
Disassembling the mowing head
To remove residue of line:
: Hold the mowing head steady and
rotate the cap (1) counterclockwise
until it can be removed.
: Pull the spool (2) out of the mowing
head (3) and remove the remaining
line.
FS 45, FS 46